ZIEHL MINIPAN 300, Руководство по эксплуатации

Страница: 6 / 12

date / name ) : 06.09.07 WL / Fz/Fu Z. Nr.: 12110-0710-01
Page 6 of 12 Type: Minipan 300
ZIEHL industrie-elektronik GmbH + Co KG, Daimlerstr.13, D-74523 Schwäbisch Hall, Tel.: +49 791 504-0, Fax: -56, e-mail: info@ziehl.de
Examples:
InPU ScAL InLo InHi diLo diHi dP
Input 0..10 V
Display 30..100 %
10 USEr 0.00 10.00 30 100 0000.
Input 4..20 mA
Display 0..100 %
4-20 USEr 4.00 20.00 0 100 0000.
Input 0..20 mA
Display 50.0..500.0
0-20 USEr 0.00 20.00 500 5000 000.0
Input 10..90 V
Display 50.0..500.0
100 USEr 10.0 90.0 500 5000 000.0
Input 0-60 mV
Display 0,0..30.0
300 USEr 0 60 0 300 000.0
Input 2..5 V
Display -50.0..100.0
10 USEr 2.00 5.00 -500 1000 000.0
Confirm and change to next menu with Set.
Delay of Display (recommended at unstable signals)
Select menu item with Up/Down until display ddiS and programmed value alternate.
Change into parametrizing mode with Set and set delay of display with Up/Down.
Now the measured value will be written into the display every 0,1 ... 2 s.
Confirm and change to next menu with Set.
Fixed Digits (recommended when measured signal is very unstable or changing rapidly)
Select menu item with Up/Down until
F
and the fixed digits blinking are displayed. When no
fixed digit is programmed, the last 2 digits are dark.
Set the fixed digits:
Fi no
Fi 0 last digit fixed ( 0 )
Fi00 last digit fixed ( 00 )
These digits display 0, independent from measured value.
Confirm and change to next menu with Set.
Code-lock
Select menu item with Up/Down until display Code programmed state alternate.
Here the parameters can be protected by activating the code-lock. After pushing Set, Pin is
displayed. Change to Pin 504 with buttons Up/Down (factory setting). After pushing Set the
code-lock can be activated or de-activated. After pushing Set again, an individual Pin
Can be selected (write down)
With activated code-lock, all parameters can be seen but not changed any more.
In case of problems with the code-lock (forgotten
Pin
), the lock can be switched off and the
Pin
can be set back to
504
,by pushing the button Set/Reset while connecting the device to
supply voltage until
Code
/
ofF
is displayed.