Pet-Immune Function
How to set:
This sensor adopts a special design to improve detection accuracy. Pets less than 25kgs
Open the rear cover of the detector; change the array of jumpers on the zone setting to
will not trigger the alarm.
the corresponding position as below (Mind the direction of D0-D3):
Zone Mode of Sensor
Sensors can be placed in different zones for different requirements. Four different zones can
be selected:
Normal zone:
In arm or home arm state, the detectors set to normal zone work
normally. Once intrusion is detected, the detectors trigger an alarm.
Home zone
:
When system is in home arm state, the detectors set to home zone are
disarmed. The detectors set to other zones are armed. That is, partial arm.
Single delay zone:
Detector set to this zone will alarm at the specifed time (which can
set by yourself) after being triggered.
24-H zone
:
The detector set to 24-H zone trigger an alarm immediately when detecting
intrusion,no matter the system is armed or disarmed.
Sensors in This Kit
Zone Mode (Default Setting)
Door/Window Contact
Normal Zone
PIR Motion Detector
Home Mode Zone
You can set zone by changing the jumpers in detector. After the setting, detector can
work in corresponding mode. It must be paired to the control panel again.
