C. Model LAS-FLB/PPMB
This square tube mount may also be used in conjunction with the LAS-FLB castings. This option
allows mounting of pike pole mounting brackets in addition to folding ladder brackets. May not be used
if option D is used (Figure 18, page 28).
D. Model PPMB-
Pike pole mounting brackets may be attached directly using pre-drilled holes on the top side of the
inside arm castings (item 2, page 15 and Figure 19, page 28). Either single or double mounts may be
used. Refer to the current ZICO catalog to order the pike pole mounting brackets required. This option
may not be used if option C is selected.
E. 1-1/2" Spacer Set (P/N 3097-250-000)
In some instances the Ladder Access Systems must be raised up to accommodate extra-wide
ladders. When this occurs, a set of four 1-1/2" high spacers will be required (item 57, page 15) for
proper mounting of the ladders. Required whenever the 27" long channel (item 54, page 15) is needed
(see Chart 3, page 18).
F. Model LAS-LGK
Ladder Guard Kit contains one tube of epoxy and two stainless steel guards. The guards may be
attached to the ladder rungs to prevent wear and possible damage as the result of the locking handle's
contact with the rung (see Figure 30, page 39).
G. Model LLAS-MLS or Model LLAS-BHM-MLS
The Manual Locking System (Figure 24, page 33) provides a positive means of retaining the
ladders. The base casting for the LAS System was changed to add a new higher center section to
accommodate a locking system. We started shipping LAS Systems with the new base casting on
March 23, 1998. LAS-BHM Systems have been using a new base casting since September 16, 1998.
The lock must be de-activated prior to operating the electrical control. This is done by pulling outward
on the strap (item 99, page 33) or pushing back on the handle (item 77, page 33).
H. Model LLAS-ELS or Model LLAS-BHM-ELS
The Electric Locking System (Figure 27, page 36) is activated by pressing down on the operating
switch allowing the small electric actuators to open the locking mechanisms. After a momentary delay,
the main electric actuators lower the System. The electric locking system may also be operated
manually (see page 36).
-3-
Содержание QUIC-LIFT LAS-775
