Zhone 891630, Справочное руководство системы

Страница: 283 / 494

Reference Guide IMACS System Release 5.1.9 6-23
Interface Card Interface Card User Screens and Settings
6.3.5 Ports Screen
You also must configure each of the Interface card’s user interface ports. This is done from the
Ports Screen, which is shown in Figure 6-11. To go to this screen, press “
p ” in the Interface
Card Main Screen ( Ports command).
Figure 6-11. Typical Ports Screen (INTF+M)
This screen shows the Protocol, Rate, Communications, and Handshaking control settings for
each port. The VT column lists the current settings for a VT100-compatible terminal
connected to the TERM modular jack on the Interface card faceplate. The C1 column is for an
external computer connection to the COMP (or COM1) DB-9 plug on the card. The M column
is for a modem connection from an INF+M card to a remote facility via a phone line.
The screen settings are described in the following paragraphs.
Note: There are two scenarios in Figure 6-11. The Typical INTF+M Ports Screen shown
above displays (VT - VT100 terminal, C1 - COM1, and M-Modem). However, if
INTF+E is used the screen will display (VT, C1, and C2 - COM2).