137 of 184
MAINTENANCE AND USE MANUAL
furnace D
EN
To start the oven immediately proceed as follows:
A.
After establishing the settings as per paragraph 7.3 press
CYCLE
(
9
):
- the on-key
LED
(
9
) comes on.
- the current in-oven temperature appears on the display (
4
).
-
the
LOAD ON LED
(
3
) comes on (and stays on throughout the work cycle) to indicate that
the oven is heating.
-
the
HEATING LED
(
1
) comes on to show that the element is on.
B.
The in-oven temperature increase is shown on the display (
4
).
C.
If you wish to stop the cycle in progress press
CYCLE
(
9
).
The
word
OFF
appears on the display (
4
).
D.
If you wish to vary one or more parameters while the cycle is running proceed as follows:
-
press
CYCLE
(
9
).
- the word
OFF
appears on the display (
4
).
- change the data by pressing
PROG.
(
11
) (see paragraph 7.3.1).
- restart the cycle by pressing
CYCLE
(
9
) again.
E.
Once the set temperature has been reached the following occurs:
- a beeper sounds for a few seconds.
- the set temperature remains constant unless altered by the operator.
-
the
HEATING LED
(
1
) comes on to show that the element in the firing chamber is on to
maintain the set temperature.
F.
Once fusion has been completed, proceed with termination of the heating cycle and switch
off the oven as follows:
-
press
CYCLE
(
9
).
- the word
OFF
appears on the display.
- press the main switch (
7
).
7.3.2
Immediate start
Should you wish to proceed with gradual firing/fusion of the lining cylinders
proceed as explained above in point (E.).
