136 of 184
MAINTENANCE AND USE MANUAL
furnace D
EN
After effecting the settings described in paragraph 7.3 proceed as follows:
A.
Press
PROG.
(
11
). The
TIMING LED
(
2
) comes on.
On the left-hand side of the display (
4
) there appear two numbers and a point indicating
the delayed start setting.
B.
Set the number of hours by pressing:
• the “
+
” key (
12
) to increase the parameter shown on the display (
4
).
• the “
-
” key (
13
) to decrease or reset it.
C.
Press
PROG.
(
11
). Two numbers indicating the delayed start minutes will appear on the
right-hand side of the display (
4
).
D.
Set the number of minutes by acting on the “
+
” (
12
) or “
-
” (
13
) keys as explained
previously in point (
B.
)
E.
Press
PROG.
(
11
). The
°C LED
(
6
) comes on.
F.
Set the temperature via the display (
4
) by acting on the “
+
” (
12
) or “
-
” (
13
) keys.
G.
Press
PROG.
(
11
). The
°C/MIN LED
(
5
) comes on.
H.
Set the temperature increase rate (in °C per minute) via the display (
4
) by acting on the “
+
”
(
12
) or “
-
” (
13
) keys.
I.
Press
PROG.
(
11
). The legend
U 300
appears on the display (
4
) to indicate variable fan
switch-off temperature (see paragraph 7.4). To vary the setting act on the “
+
” (
12
) or “
-
” (
13
)
keys.
Press
PROG.
(
11
) to save. The word “
OFF
”. reappears on the display.
L.
Press
DELAY CYCLE
(
10
).
The on-key LED comes on.
The set time appears on the display (
4
) and will start counting down.
The
TIMING LED
(
2
) comes on and will stay on until the oven switches on as
programmed.
M.
At the moment of programmed start the following occurs:
• the current in-oven temperature appears on the display (
4
).
•
the
LOAD ON LED
(
3
) comes on.
•
the
HEATING LED
(
1
) starts flashing to show that the heating phase set by the operator
has
begun.
7.3.1 Delayed start
To vary the data settings repeat the above procedure.
The situation at the moment in which programmed heating begins is exactly
as described in paragraph 7.3.2.
