143 of 188
MAINTENANCE AND USE MANUAL
furnace DE
EN
Equipment safety devices/guards must never be removed except for repair and
maintenance purposes.
Such items must be replaced as soon as the situation which led to their removal
no longer exists and in any case before the equipment is used again.
8.3
UNSCHEDULED MAINTENANCE
Modifications which alter the equipment characteristics from a safety and
risk prevention viewpoint may only be made by the Manufacturer who shall
then issue a certificate stating that the equipment conforms to safety standards.
Therefore any modification or maintenance tasks not actually described in
this manual are to be considered forbidden. If the equipment is modified,
tampered with or repaired by unauthorised personnel or non-original spare
parts are used the manufacturer is relieved of all responsibility. If a maintenance
task is required but is not described in this manual you must contact an
Authorised Servicing Centre.
All electrical and mechanical work must only be carried out by an authorised
Zhermack S.p.A.
maintenance technician.
8.4
RESTARTING AFTER A LONG PERIOD OF INACTIVITY
Should the equipment be used after remaining idle for a long period proceed as described in
Chap. 6 (start-up) and, if necessary, re-enter the data as described in Chap. 7.
If there are any faults or malfunctions proceed as described in Chapter 9 (Troubleshooting). If the
problem persists or is not covered by the information in this chapter contact your Authorised
Servicing Centre immediately.
8.5
REQUESTING TECHNICAL ASSISTANCE
To obtain technical assistance choose one of the following options:
1.
contact your Authorised Servicing Centre.
2.
telephone the
Zhermack S.p.A.
Customer Assistance Service on the number
+39 0425.597.611
and proceed as follows: give personal data (e.g. address and telephone n.),
state the information on the equipment ID plate (see paragraph 3.3) and explain the
problem clearly.
3.
fax all the above information and a properly filled out ID Form (see Appendix 2) to
+39 0425.53.596
.
