Zgonc Yellow GARDEN LINE 720 YGL N.G. NEW..., Перевод оригинального руководства пользователя

Страница: 53 / 64

5 Remove the frame cover(s) from the underside of the snow thrower by removing
the screws which secure the cover(s).
6 Slip the drive belt off the pulley and between friction wheel and friction wheel disc.
7 Remove and replace belt in the reverse order.
Holding down the drive clutch lever will ease reinstallation of the belt.
If an assistant is available, you can also separate the auger housing from the frame
assembly to replace belts.
1. Shut off engine, remove key, dis connect spark plug wire and allow unit to cool
completely.
2. Remove belt cover.
3 Remove the shaft gear cover and pull the shaft blocking cable, the baffle cable
and the ejection shaft control rod.4 Remove bottom cover to avoid bending it when
tipping unit apart.
5 Remove the screws securing auger housing to the frame (two on each side). Kip-
pen Sie das Einzugsschneckengehäuse und das Gestell so, dass sie auseinan-
dergehen.
6 Replace auger belt or drive belt.
7 Tip the feed screw housing and frame so that it folds together and secure it with
the bolts.
Holding down the auger clutch lever will ease reconnection of the auger housing
and frame.
8 Place belt(s) onto engine sheave(s).
9 Re-install shaft blocking cable, the baffle cable and the ejection shaft control rod.
10 Re-assemble the shaft gear cover and the belt cover.
Friction wheel replacement with wheel drive
If the snow thrower fails to drive with the drive clutch engaged, and performing the
clutch control cable adjustment fails to correct the problem, the friction wheel may need
to be replaced.
1 In order to prevent spillage, remove the fuel from the tank by closing the fuel valve
and running the engine until it stops. Then, open the tank cap and let the petrol
completely drain into a sufficiently large container by tilting the machine or sucking
it out. Then, close tank cap again.
2 Carefully pivot the snow thrower up and forward so that it rests on the auger hous-
ing.
3 Remove the frame cover(s) from the underside of the snow thrower by removing
the screws which secure the cover(s).
4 On wheeled model, remove the right-hand wheel by removing the axle lock pin.
53
D GB