Zetronix zHunter-500HD, Руководство пользователя

Страница: 17 / 19

8. Trouble Shooting
2.0C series Camera won’t power on
1. Make sure that you have installed at least 4 batteries in the battery compartment all stacked
together.
2. Make sure that the batteries are installed correctly.
3. When moving the switch from “Off” to “Test” or “On”, the user should make sure that the
switch stops in a positive position to ensure the proper mode (and do not move the switch too
fast).
a. the voltage should be between 4.5V and 6.5V;
b. in Test mode, camera will automatically power off if there is no operation in 1 minute.
4. Make sure batteries power is enough; or else, camera may power off suddenly when IR leds
is on in TEST mode.
2.0C series hunting camera stops sending photos to email or mobiles.
1. Check if the SIM card is out of charge.
2. Check SIM card MMS function with mobile phone.
3. Check if the signal is too weak or there is no signal.
4. Make sure the GPRS setting is right (check the manual)
2.0C series hunting camera stops taking images or won’t take images
1. Please make sure that the SD card is not full. If the card is full, the camera will stop taking images.
2. Check batteries to make sure that they are new alkaline or lithium AA batteries.
3. Make sure that the camera power switch is in the “On” position and not in the “Off” or “Test”
modes.
4. When GPRS function is on, there will be 1 minute interval before camera shooting the next
photo . Turn off the GPRS, camera can shoot photos continuously.
5. Please format the SD card with 2.0C huntingcam before using or when camera stops taking
images.
Photos Do Not Capture Subject of Interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting. For warm environmental
conditions, set the Sensor Level to “High” and for cold weather use, set the sensor for “Low”.
2. Try to set your camera up in an area where there is not a heat source in the camera’s line of sight.
3. In some cases, set the camera near water will make the camera take images with no subject in
them. Try aiming the camera over ground.
4. Try to avoid setting the camera up on small trees that are prone to being moved by strong winds.
5. Remove any limbs which are right in front of the camera lens.
9. Available Models, IR LEDs, and Case Colors
1. Two different models with the same case:
- 15 -