ZEROXCLUB Instructions Manual
9
●
Connect the extension wire to 4pin plug from the monitor. All the
cables you will need will come provided in the backup camera kit.
●
Do not pull aggressively on the connector head of the cable when
you are routing the cables though channels or tight spaces as this
may damage the fine wires in the cable. Use a fish tape to thread
the cables though these areas. Tape the cable securely to the fish
tape to distribute the load when the tape is pulling the cable though
the tight spots.
●
When you install the 4pin cable,
please target every pin to the hole,
avoid breaking the pin. When the
system is set-up the cables may now
be properly secured and stowed.
●
After connecting the wires, pay attention to the insulation
between the power cables to prevent the power cables from
short-circuiting the battery.
●
Use plastic split-shield cable covers where appropriate to protect
the cables in open areas.
●
Secure the cables using adhesive 3M type
¼”
cable clips and/or
zip ties.
●
You may have surplus cable length remaining in your installation.
If this is the case, find a convenient place to bundle the cable with
zip ties and securely hide it out of site. We do not recommend
shortening the cable by cutting and rejoining it.
●
You should also make sure the monitor only starts after ignition,
so that you can preserve your battery. You can find the
corresponding connection for the fuse box according to the manual
for your car and model.
NOTE:
