Zeppelin Design Labs VPM-1, Инструкция по сборке

Страница: 46 / 56

46
3. Align the sensor board with the top of the potentiometer block and add a drop of super glue to the
back, top edge of the block (156). This should affix the sensor board to the block to keep it from
rotating as the pedal gets hauled around from gig to gig. It may be necessary to hold the board
down to the top of the block as the glue sets to ensure the board is laying on the surface of the
block. Once the glue cures you can tighten up the screw a bit more, if needed.
156 157
4. With the sensor board screwed and glued in place, you can now re-install the potentiometer block
in the pedal chassis (158). Remember, the two longer screws are used to attach the potentiometer
block. There is some play in how this block fits inside the pedal so snug the screws down but don’t
tighten them up tight. Visually line up the sensor board so it is aiming straight to the back of the
pedal (159), then tighten the screws.
158 159
160