Zephyr MATRx Plus, Инструкция по эксплуатации

Страница: 20 / 21

20
Federal Communications Commission Notices
This product complies with Part 15 of the FCC Rules� Operation is subject to the following two conditions:
1. This device may not cause harmful interference�
2.
This device must accept any interference received, including interference that may cause undesired
operation�
Caution
Changes or modifications to this equipment that have not been approved by Zephyr Sleep Technologies may
void the user’s authority to operate this equipment�
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules� These limits are designed to provide reasonable protection against harmful
interference in a residential installation� This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications� However, there is no guarantee that interference will not occur in a articular installation�
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Manufacturer Declaration for Emissions
Note
“Harmful interference” is defined by the FCC as follows: Any emission, radiation or induction that endangers
the functioning of a radio navigation service or of other safety services or seriously degrades, obstructs or
repeatedly interrupts a radio-communications service operating in accordance with FCC rules�
Industry Canada Statement
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada� To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e�i�r�p�) is not more than that necessary for successful communication�
This device complies with Industry Canada license-exempt RSS standard(s)�
Operation is subject to the following two conditions:
1.
This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation
of the device�
Radiation Exposure Statement
The radiated energy from the MATRx plus conforms to the FCC limit of the SAR (Specific Absorption Rate)
requirement set forth in 47 CFR Part 2 section 1093� The radiated energy from the Zephyr Wireless MATRx plus
antennas conforms to the IC limit of the RF exposure requirement regarding IC RSS-102, Issue 2 clause 4�2�