8
The film back consists of a film holder which will be loaded with a roll
of film and a film back frame which completely encloses the film
holder and shields it from light.
* The Film Back SQ/B 120 is for exclusive use of 120 roll film. For load-
ing 220 roll film, use the optional Film Back SQ-I 220.
* To take other format pictures such as 6 x 4.5cm, 24 x 35mm, 24 x
54mm or Polaroid pictures, use exclusive film backs.
A. Open the back cover by squeezing the back cover release button
toward each other, then remove the film holder.
* Note, when you load the first roll after opening the camera package
and empty film spool is in the bottom spool holder you do not need
to transfer the empty film spool from the top to the bottom film
holder as instructed next.
B. Remove the empty film spool pre-inserted in the top spool holder
of the film holder by pushing up the spool in the arrow-indicated "A"
direction. Insert the empty spool to the bottom spool holder by
pressing out the left-hand bottom shaft and aligning the spool key
hole with the right-hand shaft. Insert a fresh film spool into the top
spool holder aligning the right-hand key hole of the film spool with
the top-right shaft, then close the left-hand shaft to securely hold the
film spool.
C. After loading the fresh film spool properly, draw out the leading
end of the film and turn it across the film pressure plate (as illustrat-
ed). Run it down and turn it over to take up spool. Insert the leading
end into the slit of the take-up spool and wind slightly until securely
engaged.
* The inside black surface of the leader must face out when running
across the pressure plate.
4. Construction of Film Back
5. Film Loading
