Zenoah GZ4350, Руководство по ремонту

Страница: 29 / 62

English -
28
Repair Instructions
7.9 Assembling the ignition module and
flywheel
1
Place the ignition module in position and fit the
screws. See figure 13. Do not tighten the screws.
Fig 14
Fig 15
2
Fit the flywheel onto the crankshaft pin. Turn the
flywheel until the key fits into the key slot on the
shaft. See figure 14.
Tighten the nut for the flywheel.
3
Insert the plastic air gap tool, at a thickness of
0,4 +- 0,1 mm, between the lugs on the ignition
module and flywheel. See figure 15.
Turn the flywheel so that the magnets are posi-
tioned opposite the ignition module. Tighten the
screws, at a tightening torque of 2,5-3,9 Nm. Re-
move the plastic air gap tool.
4
Attach the ignition cable to the ignition module.
5
Then fit the:
• air guide plate and press the cable in place.
• starter, at a tightening torque of 2,5-3,9 Nm.
• cylinder cover and air filter cover.
Fig 13