GB-10
G3000
WARNING
It is very dangerous to run a chainsaw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts in-
cluding bar and chain are installed properly.
■
STARTING THE ENGINE
WARNING
Keep clear of the saw chain as it will start rotating
upon starting of the engine.
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely.
Fuel
Chain oil
2. Push the primer pump until fuel flows out in the clear
tube.
Primer pump
3. Put the ignition switch to “ I ” position.
Ignition switch
4. While holding the throttle lever together with the
throttle interlock, push in the side button and release
the throttle lever to hold it at the start position.
Throttle interlock
Side
button
Throttle lever
5. Operating the Engine
5. Pull out the choke knob to the closed position.
Choke
knob
NOTE
When restarting immediately after stopping the engine,
Ieave the choke knob at the open position.
6. While holding the saw unit securely on the ground,
pull the starter rope vigorously.
WARNING
Do not start the engine while hanging the chain saw
with a hand. The saw chain may touch your body.
It’s very dangerous.
7. When firing occurs, push in the choke knob and pull
the starter again to start the engine.
8. Allow the engine to warm up with the throttle lever
pulled slightly.
■
CHECKING OIL SUPPLY
WARNING
Make sure to set up the bar and the chain when
checking the oil supply.
If not, the rotating parts may be exposed. It is very
dangerous.
After starting the engine, run the chain at medium speed
and see if chain oil is scattered off as shown in the
figure.
