Zenoah EBZ7500, Руководство по ремонту

Страница: 44 / 60

-４２-
7
.
Notice of Reassembly
7-18 RHD-Throttle Lever Set Assembly
1. Make an alignment line at 2.2 mm from the end
of the shaft.
2. Set the control lever to the left handle half, and
install the rubber spring and the washer while
inserting the shaft. Apply grease between the
washer and the lock washer.
3. Push the lock washer straight to the shaft and
attach the control lever to the left handle half.
NOTE:

When pushing the lock washer, align the
projections of the lock washer with the
alignment line marked in step 1.

If the lock washer is set inside of the
alignment line position, the operation of
the control lever may become too heavy.
The lock washer may need to be pushed more
again when control lever returns automatically
during operation.
Control lever operating torque:
0.41
～
0.52N
･
m (4.2
～
5.3kgf
･
cm)
4. Match the color of the switch cords and the
shape of the contact plates as shown and
connect the terminals to the contact plates
5. Place the contact plates and the switch cords on
the left handle half.
NOTE:

Set the clearance at the tip of the contact
plates to 1 mm or more.

When wiring the switch cords, place the
red cord to the handle side and press them
into the guide groove.
Washer
Rubber Spring
Shaft
Control Lever
2.2mm
Alignment Line
Shaft
Left Handle Half
Lock Washer
Alignment Line
Lock Washer
(Projection)
Shaft
Black-
Switch Cord
Red-Switch Cord
Contact Plate
(Red side)
Contact Plate
(Black side)
1mm or more
Red-Switch Cord
Guide
Grooves
Guide
Groove
Contact Plates