KLIC-DD3
http://www.zennio.com
Technical Support:
http://support.zennio.com
5
Figure 2.
Connecting KLIC-DD3 to the A/Cunit.
Important
:
Control the A/C unit both through its incorporated wired remote control and
through KLIC-DD3 is not possible, due to both of them use the S21 port. By the other
hand, if the wireless control is employed, it must be taken into account that orders sent
from the wireless control will have a higher priority than those sent through KLIC-DD3.
In addition, certain parameterisations made in the device can be ignored.
For detailed information about the technical features of KLIC-DD3, as well as on
security and installation procedures, please refer to the device
Datasheet
, bundled in
the device packaging and also available at
http://www.zennio.com
.
1.3
START-UP AND POWER LOSS
Depending on the configuration, some specific actions will be performed during the
device start-up. The integrator may set up an initial status to be sent to the A/Cunit
after the bus power recovery, and whether certain objects should be sent to the bus
after the power recovery, as described in later sections.
On the other hand, when a bus power failure takes place, the device will interrupt any
pending actions, and will save its state so it can be recovered once the power supply is
restored.
