KIPI SC v1.1
Technical Support:
8
2
CONFIGURATION
After importing the corresponding database in ETS and adding the device into the
topology of the desired project, the configuration process begins by entering the
Parameters tab of the device.
2.1
KNX TO IP INTERFACE
KIPI SC
interconnects a KNX bus and an Ethernet network (LAN)
.
On the other hand, KIPI SC can be allocated within the project topology in ETS, as any
other device. This step can be omitted when it is going to be used as interface, because
there is no need to modify the default configuration (see previous section). However,
when requiring to modify any property of KIPI SC, an individual address should be
assigned in order to download.
2.1.1
PROGRAMMER
KIPI SC can be used in ETS as a
programming interface
. In addition to an IP address,
they must be assigned a KNX individual address for this purpose.
Up to five simultaneous connections
are allowed for performing downloads or for bus
monitoring (via group monitor).
Note
:
to detect the KIPI SC as a programmer in ETS, it needs to be connected to the
same IP network as the PC
.
To use a device as a programmer simply select it in the ETS "Bus" tab under Connections
→
Interfaces.
