KIPI SC v1.1
Technical Support:
5
1.2
INSTALLATION
Figure 1.
Element Diagram
Figure 1 shows a scheme with all the LED indicators and required connections. This
device does not require an external power supply, it is powered through the KNX bus.
To couple a KNX twisted-pair (TP) line and a LAN network, the KNX bus (6) and Ethernet
(1) cables must be connected. After the connection, the device can be conveniently
mounted on the DIN rail by the usual procedure
The programming button (8) shown in
Figure 1 programming button (8) may be pressed to set KIPI SC in
programming mode
.
After a short press, the programming LED (7) will light in red.
Note
:
if the programming button is held while plugging the device into the KNX bus, the
device will enter into
safe mode
. In such case, the LED will blink in red every 0.5
seconds.
The behaviour of the additional LEDs and the factory reset button will be described in
For detailed information about the technical features of the device, as well as on security
and installation procedures, please refer to the device
Datasheet
, bundled within the
original packaging of the device and also available at
1. Ethernet connector.
2. KNX LED indicator.
3. Ethernet LED indicator.
4. -
5. -
6. KNX connector.
7. Programming LED.
8. Programming button.
9. Factory reset button.
10. Factory reset LED indicator.
3
2
5
4
6
1
7
8
9
10
