AudioInRoom
http://www.zennio.com
Technical Support:
http://support.zennio.com
6
1.3
INSTALATION
AudioInRoom is connected to the KNX bus through the built-in terminal (2). This device
requires an
external
24V DC
power supply
(1).
Figure 2.
AudioInRoom.
A short press in
Programming Button
(4) will make the device enter the programming
mode. The
Programming LED
(3) will then light in red. On the contrary, if this button is
held while the device gets connected to the bus, AudioInRoom will enter the
safe
mode
. In such case, the programming LED will blink in red colour.
Moreover, a 3 seconds press in
Testing Button
(8) turns the Bluetooth module on and
sets the device into
pairing mode
. The
Testing LED
(9) will light:
In blue when the Bluetooth module is on.
In green when pairing is active.
Flashes red in the absence of KNX bus voltage, blending with the other
colours if several notifications are made at the same time.
If a device without a Bluetooth module is to be connected, it must be connected via the
audio auxiliary input
(6). Figure 3 shows the correct AudioInRoom auxiliary input
connection, depending on whether a Jack analogue audio connector or an RCA
connector is used:
1.
24VDC Power Supply.
2.
KNX Connector.
3.
Programming LED.
4.
Programming Button.
5.
Not used.
6.
Audio Auxiliary Input.
7.
Ventilation Grill.
8.
Testing Button.
9.
Testing LED.
10.
Audio Output Channels.
44
,2
5
144,26
22
,7
1
3
2
5
3
6
1
4
7
8
9
10
1
2
3
4
5
6
7
8
9
10
