ZENN
iO
AVANCE Y TECNOLOGÍA
vwww.zennio.com
9
3. ETS PARAMETERIZATION
For starting to parameterize the ACTinBOX MAX6 actuator it is necessary, once the ETS
program has been opened, importing the data base of the product (version 3.0 of the application
program).
Next, the device is added to the project where desired. Click the right mouse button on the device
and select "Edit parameters" for starting with the configuration.
In the following sections there is a detailed explanation about each of the different functionalities of
ACTinBOX MAX6 in ETS.
3.1. DEFAULT CONFIGURATION
This section shows the default configuration from which the device parameterization starts.
When entering for the first time to the parameters edition of ACTinBOX MAX6, the following window
will be shown:
Figure 3.1. Configuration screen by default
As seen in figure 3.1, the outputs and the logical functions are disabled by default, so there will be
no communication objects available until the user enables the different functionalities of the
actuator.
If the parameter "Sending of Indication objects on bus voltage recovery" is enabled, two new 1-bit
communication objects will appear ("Reset 0" and "Reset 1"), which allow sending to the KNX bus
the values "0" and "1" after a bus power failure, in order to recover the communication with the rest
of the devices in the installation. This sending may be immediate or after a configured delay (in
seconds).
