Zenner MinoConnect, Руководство по установке

Страница: 4 / 12

4
English
Introduction
The MinoConnect transmission device serves for remote
reading and configuration of the consuming appliances
respective M-Bus or radio systems either by means of op-
tohead, serial interface or via radio.
MinoConnect partially replaces the cable connection bet-
ween a serial device and a PDA/PC by a Bluetooth con-
nection.
Devices that can be connected via RS232 with SubD 9
Plug to a computer can now be connected to MinoConnect
The further connection to the PC/PDA is then via Bluetooth.
To be able to use all the functions, ZENNER GMM soft-
ware must be used.
Walk-by application: It is possible to receive data protocols
with MinoConnectRadio without using GMM-Software.
For reading and configuration of meters with radio interface
(e.g. wM-Bus) ZENNER offers various software solutions.
Before first commissioning of the device, please insert the
two supplied batteries (NiMH 1.2V min. 2.700 mAh) with
respect to the marked polarity into the battery compart-
ment. Then charge the device about 5 hours.
Switching on
MinoConnect is turned on by a short press (approx. 2s)
on the yellow button (until at least one LED is lit). When
switched on, the power LED flashes green.
Switching off
In the ON-state please press and hold the button till the
power LED light up again (about 3 seconds). Then release
the button.
Please note: The MinoConnect has an Auto Power Off
function. If during the time period the button is not pressed
and no commands are received, the device switches itself
off automatically. By command, the switch-off time can be
set via the interface (only with GMM).
Bluetooth-Pairing
If the MinoConnect is paired with a device e.g. laptop or
smartphone, the blue Bluetooth-LED will flash and he is
not visible for more devices.
To pair with another device, please proceed as described
below.
States and actions
For a better view, but also for the diagnosis and possibly error detection in a system, MinoConnect shows the most impor-
tant states and actions with 7 coloured LED:
LED Function
Remarks
TxD
Indicates that a data transmission from MinoConnect to the connected device
is being carried out
-
RxD Indicates that data are being sent from the connected device to MinoConnect -
3.3V 3.3 Volt are available at the pin for the external supply voltage
for ex. MinoHead
7V 7 Volt are available at the pin for the external supply voltage
for ex. ZENNER Optical head
Power
lights after power-on, the power LED signals by different flash frequencies the following modes:
Blink interval State
■
2.4 seconds
■
0.6 seconds
■
0.12 seconds
⇒
Bluetooth connection is established
⇒
No Bluetooth connection
⇒
Battery capacity low, reload immediately! This display also occurs when a connected
device requires too much power (for example: short circuit).
Charge Charging light. With a connected supply it lights until the batteries are fully charged.
Bluetooth
The flashing Bluetooth LED displays that the device is paired with another Bluetooth device.*
The constantly lighting LED displays, that the device is connected with another Bluetooth device.
*
Note: The flashing is only visible after a power cycle.