Pg 8 of 32
www.zennahome.com IS072D2-I
Permanent Mount
• Measure the space between the walls of the bathtub or shower where your rod assembly will be installed.
•
NOTE: Please write down your measurement below, you will need this later.
• NOTE: ASSEMBLE ON A SMOOTH FLAT SURFACE.
•
On the 7/8 in. diameter tube assemblies (C), twist the tube in the direction of the arrow sticker by
2 turns
,
making the assembly longer,
fig 1
.
•
Now, extend the rod assembly to the measurement from step 4 and lock the length of the assembly
with the rod set screws (4) using the small hex wrench (6).
NOTE:
Tighten the rod set screws (4) until it is
flush with the rods,
fig 2
.
Step 4 - Measure the space between the walls.
Measurement
between walls:
Step 5 - Extending the 7/8 in. Rod and installing the Set Screw.
rod assembly
C
Fig. 1
Fig. 2
twist the tubes
in the direction of the
ARROW STICKER
D
4
D
