7
598-1306-07
ENGLISH
Installation
1. Select light switch to be replaced by wall switch receiver.
2.
WarNING: turn off the power to the light switch circuit
before you proceed.
Do this at your circuit breaker or fuse box.
3. Remove the existing wall plate and switch. Disconnect the two
power wires and the ground wire.
Note:
If there are more than two power wires attached to the switch,
consult an electrician about installation. In addition, some local build
-
ing codes may require installation by a qualified electrician.
CautIoN: do not connect neutral (white wire) to
switch.
Important:
When ganging these units, they must be derated as
follows:
Features and Ratings:
• Up to 500 Watt maximum incandescent load depend
-
ing upon switch purchased. See rating label on switch
for exact load rating.
• Not for use with Compact Fluorescent bulbs.
WarNING: For uSE oNLY with 120 volt incandescent
or halogen bulbs.
CautIoN: to reduce the risk of overheating and pos-
sible damage to other equipment, do not install to control a
receptacle, a motor-operated appliance, a fluorescent lighting
fixture, or a transformer-supplied appliance.
WaLL SWItCH rECEIvEr
Gang
1
2
3
300 W
300 W
300 W
300 W
500 W
500 W
475 W
450 W
rECEIvEr INForMatIoN
All receivers have the following features and ratings:
• Rated for 120VAC/60Hz supply voltage.
• Uses existing wiring.
• Fits standard single gang junction box (wall switch only).
• Not for use with Compact Fluorescent bulbs.
• When first turned on wait 15 seconds.
Battery replacement
The entry transmitter requires a type CR2032, 3-volt lithium
battery to operate. The transmitter is shipped with the battery
installed. With typical use, the battery will last approximately five
years. Remove battery when transmitter will not be used for an
extended period of time.
1. Remove transmitter from transmitter back cover using small,
flat-blade screwdriver.
2. Carefully pry battery loose with small, flat-blade screwdriver.
Battery will pop up.
3. Install replacement battery in socket plus (+) side up (see illustra
-
tion). Press down on battery until it snaps into place.
4. Snap transmitter onto back cover.
Note:
The magnet does not require a battery.
CR2032
3 VOL
TS
CR2032 Lithium Battery
Flat-Blade
Screwdriver
Battery Replacement
Transmitter
Continued
