Zenit JS-1050M, Инструкция по эксплуатации

Страница: 6 / 10

6
5.1 Open the lever up to the stop.
5.2 Remove fitted blade
5.3 Insert new blade up to the stop in the blade holder
5.4 Close the lever
CAUTION!
Be sure to switch power OFF and disconnect the plug from the receptacle when chang-
ing blades.
Do not open the lever when plunger is moving.
NOTE!
Confirm the protrusion of blade inserted to the blade holder surely. Confirm the blade
located between the groove of roller.
6. Adjusting the blade operating speed
The jig saw is equipped with the electric control circuit which enables stepless speed
control. To adjust the speed, turn the dial. When the dial is set to “1”, the jig saw oper-
ates at the minimum speed (500 /min.). When the dial set to “5”, the jig saw operates at
the maximum speed (3000/min.). Adjust the speed according to the material to be cut
and working efficiency.
7. Cutting stainless steel plates
This Jig Saw can cut stainless steel plates by using No. 97 blade. Carefully read “Con-
cerning cutting of stainless steel plates” for proper operation.
8. Splinter guard
Using the splinter guard when cutting wood materials will reduce splintering of cut
surfaces.
Insert the splinter guard in the space on the base, and push it completely.
9. Chip cover
Chip cover prevents chips from flying off and improves the efficiency of dust collector.
Insert the chip cover between the base and lever, and push with a slight pressure until it
catches in place. When removing chip cover, hold both sides of knob and slightly open
until it can be removed from the Jig Saw
NOTE! There is a possibility that chip cover is frosted when cutting the metal.
10. Sub base
Using the sub base (made from steel) will reduce abrasion of aluminum base especially
in cutting metals.
Using the sub base (made from rasin) will reduce scratching of surface. Attach the sub
base to the bottom surface of base by attached 4 screws.