Zenit JS-1050M, Инструкция по эксплуатации

Страница: 8 / 10

8
NOTE: Angular cutting cannot be done when adopting chip cover or dust
collector.
connectinG with cleaner
By connecting with cleaner (sold separately) through dust collector and adopter (sold
separately), most of dust can be collected.
(1) Remove the allen wrench from the base.
(2) Move the base fully forward.
(3) Attach the chip cover with the shutter put between the chip cover and gear cover.
(4) Connect the dust collector with adopter.
(5) Connect the adapter with the nose of cleaner.
(6) Insert dust collector into the rear hole of the base until the hook catches in the
notch.
(7) Press the hook to remove the dust collector.
NOTE!
Wear dust mask when possible.
selection of blaDes
To ensure maximum operating efficiency and results, it is very important to select the
appropriate blade best suited to the type and thickness of the material to be cut.
housinG the allen wrench
It is possible to house the auxiliary wrench on the base.
Maintenance anD inspection
1. Inspecting the blade
3. Since use of a dull tool will cause motor malfunctioning and degraded efficiency,
replace the drill bit with a new one or resharpening without delay when abrasion is
noted.
4. Inspecting the mounting screws.
Regularly inspect all mounting screws and ensure that they are properly tightened.
Should any of the screws be loose, retighten them immediately. Failure to do so could
result in serious hazard.
5. Maintenance of the motor.
The motor unit winding is the very “heart” of the power tool. Exercise due care to
ensure the winding does not become damaged and/or wet with oil or water.
6. Inspecting the carbon brushes.
The motor is equipped with carbon brushes, which wear with time. When a brush