ZENEC ZEM-W1001RM, Инструкция по эксплуатации

Страница: 26 / 32

26
Step 2:
■
Connect the 6 pin power source cable, signal cable with the video adapter.
Step 3:
■
Connect the 6 pin power source cable to a 12V source, ACC and GND power source in
your car.
Step 4:
■
Pull out the original dome light power wire and signal cable through the opening of
original dome light.
Step 5:
■
Connect the signal cable to the female connector on the unit side.
■
Connect the power wire of dome light on the back unit with original dome light power
wire.
Step 6:
■
After the panel is open, fix the unit to the mounting plate with four screws and rip off
the scraps which may be conglutinated on adhesive foam. Then, use adhesive foam to
cover the four screws.
Car Roof
Metal Plate
Screw ST4.2x16 *4
INSTALLATION
Step 1:
■
Select the screw from ST4.2X16 by length that applies to your vehicle, contained in the
package contents. Screw the metal mounting plate to the car roof. Please remember not
to cover the opening of original dome light.
ZEM-W1001RM Manual D+E.indd 26 11.07.2005 10:33:56 Uhr