ZENEC Z-E3766, Руководство по установке

Страница: 5 / 6

5
8
9. (No picture)
Connect all the cables to the ZENEC system
(No. 1): those previously run in the radio slot,
and the original antenna cable. If necessary,
use the ISO DIN antenna adapter (No. 8)
included in the kit.
Next slide the ZENEC system carefully into the
radio slot until it locks in place.
COMMISSIONING
Make sure that the vehicle is outside, and that the GPS reception is not adversely affected by any
shadowing (trees, high buildings etc.). Now insert the navigation software SD card (No. 5) supplied into the
SD card slot of the ZENEC system, and start it in order to establish a sat fix. Make sure that the vehicle
is not moved until the sat fix is established. Now press the NAV button to start the navigation mode, and
choose map view. Once your present location is shown means, the sat fix has been established sucessfully.
This can take 3 to 5 minutes. You can now use the ZENEC system.
Finally carry out a general functional test, and make the basic settings. Also ensure that no fault warnings
appear on the vehicle side.
8. Connect the main cable (No. 9) of the ZENEC
system (No. 1) to the ISO plug connectors of the
vehicle.
● Make sure that all connectors at the rear of the unit have sufficient room and are not bent.
● For vehicles with an original FIAT active antenna, it is necessary to ensure a power supply for the
antenna. Pay particular attention that the plug connectors of the P.ANT lead of the main connection
cable (No. 9) are connected together.
● Connectors without a retaining mechanism must be secured with insulating tape.
NOTE