COMPATIBILITY LIST
*N-XFDUC8 device mounting frame kit required
CAUTION
- The installation of the ZENEC system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect
installation can cause damage to the vehicle and the ZENEC system.
- Correct functioning can only be guaranteed when you use the ZENEC original accessories included in the kit or optionally available. The ZENEC system and the original
accessories must under no circumstance be modified or altered in any way. Inappropriate actions can cause damage to the vehicle and the ZENEC system.
NOTE
- For the direct mounting, the target vehicle must be factory equipped with radio provision. The ZENEC system is not compatible with vehicles that are equipped
with an OE radio or OE navigation system (10” / 9”) from the factory.
- These installation instruction manual applies to vehicle platforms appearing in the above compatibility list, and in a condition as offered by the respective
vehicle manufacturer. Deviating equipment and specific adjustments to body battery-, vehicle battery, charging systems and power harness layout implemented
by the given motorhome manufacturer brand are not taken into account in these installation instructions. Please contact the relevant motorhome manufacturer.
- The ZENEC system is equipped with an integrated DAB+ twin-tuner receiver. To make use of this you will need a suitable DAB antenna (not included in kit) that
must be connected to the ZENEC system. If vehicle is equipped with ex-work OE DAB antenna, a FAKRA > SMB adapter is required for connection.
- In order to obtain better radio reception, it is recommended to equip the vehicle with an active FM / DAB roof mount car radio antenna system.
- If the target vehicle is equipped with a resistor based multifunction steering wheel (SWC), no additional accessories are needed to support the steering wheel
remote control functions. (See step 8. for Bluetooth telephony function details)
- Software updates to the ZENEC system are installed with a USB memory device. Therefore when fitting the system make sure that the USB connection of the
ZENEC system will still be accessible later (installation of an USB extension cable).
- If you have questions or problems relating to the ZENEC system, please contact the dealer from whom you purchased it.
THE KIT INCLUDES
TOOLS REQUIRED
- Torx screwdriver T25
- Phillips screwdriver
- Fabric tape
No.
Article
Qty
1
Mounting frame
1
2
Remote control
2
3
Phillips screws
4
4
Parking brake cable
1
5
GPS antenna with metal mounting plate and double sided adhesive pad
1
6
USB extension cable
2
7
Bluetooth microphone with mounting accessories
1
8
24-pin connection cable (4.2, M-Zone, AV-IN)
1
9
20-pin connection cable (Mic, Cam, IR-IN, eCall Mute, Analog SWC-IN)
1
10
ISO-DIN main harness
1
11
Main device user manual
2
12
FM antenna adapter ISO/DIN
1
13
SWC-adapter (Key 1/2)
1
Model
Type
Modell Year
FIAT Ducato III
250 / 251
2006 - 2011
FIAT Ducato III
250 / 251
2011 - 2014
FIAT Ducato III
250 / 251 (X290) „SERIE 7“
ab 2014
FIAT Ducato III
250 / 290 „SERIE 8“*
ab 2021
CITROEN Jumper III
250 / 250D / 250L
ab 2006
PEUGEOT Boxer II
250 / 251
ab 2006
Opel Movano
Typ C
ab 2021
