Zelmer zvc115, Руководство пользователя

Страница: 33 / 36

39
ZVC115-001_v01
Technical parameters
The type of the vacuum cleaner and the technical parameters
are indicated on the rating label. Mains protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing the Directive
of the European Parliament and of the Council 2009/125/EC
with regard to eco-design requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament and of
the Council 2010/30/EU with regard to energy labelling of
vacuum cleaners.
Noise level: 86 dB(A).
Static electricity
In the process of vacuuming of some surfaces in areas of
low air humidity the device may become electrically charged.
It is a natural phenomenon – it does not damage the device,
and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend you to:
●
discharge the device by touching metal items in the room
with the pipe,
●
increase air humidity in the room,
●
use widely available antistatic agents.
Design
A
1 ON/OFF button
2 Handle
3
Cord rewind button
4 Fastening of the nozzle brush or the telescopic pipe
5 Plug and cord
6 Outlet filter cover
7 Fastening of the upper cover
8 Suction power regulation lider
9 Bag repletion indicator
10 Suction hose
11 Telescopic suction tube with a fastening hook
12 SAFBAG-type bag (1 item, installed in the vacuum cleaner)
13 Outlet filter (installed in the vacuum cleaner)
14 Inlet filter (installed in the vacuum cleaner)
15 Two-function ending
a
crevice nozzle function
b brush function
16 Switchable combination brush
Before first use
B
Before starting the vacuum cleaner make sure, whether the
SAFBAG is properly installed in the chamber of the vacuum
cleaner, and whether all filters are in place as well.
1 Place the end of the hose in the opening of the vacuum
cleaner, and gently press it. A characteristic “click” signalizes
the hose has been properly installed.
2 Connect the other end of the hose (handle) with the
telescopic suction tube. In order to do so press the locking
device “A” and slide the tube into the hose handle so that
the locking device “A” is blocked in opening “B” .
3 Select the needed length of the telescopic suction pipe
by sliding the slider according to the arrow, and pulling out/in
the pipe.
4 Install a nozzle or a brush on the other end of the suction
pipe.
5
Use combination carpet & floor brush for vacuuming both
hard surfaces and carpets. To clean hard surfaces – wooden
floors, plastic floors, ceramic tiles etc. pull out the brush by
pressing the switch on the combination brush according
to the figure . Retract the brush when vacuuming
carpets (set the switch in “ ”).
6 Grab the plug of the cord (5) , and pull it out of the
vacuum cleaner.
When pulling out the cord pay attention to
the yellow band which marks the end of the
cord. Any attempts to unwind the cord further
(especially forcefully pulling on it) may lead to
damaging it.
7 Put the plug of the cord in an electric socket.
8
Press the on/off switch (1) to start the vacuum cleaner.
9 The vacuum cleaner is equipped with an electronic
suction power controller. The power adjustment is done by
means of a slider.
10
By shirting the slider in a given direction, you decrease
MIN or increase MAX suction.
(De)installing the SAFBAG-type bag
E
1
Total covering up of bag loading indicator by the red
cover in case the sucker or the brush is upraised over
the cleaned surface informs, that change of dust bag is
necessary. The bag loading indicator may operate in case
of suction hose stopping or in case of stopping of equipment
elements connected thereto.
2 Press the on/off switch (1) to stop the vacuum cleaner.
3
Remove the plug of the cord from the socket.
4 Press both of the side buttons situated on the end of the
hose, and remove the end of the hose from the inlet of the
vacuum cleaner.
5
Release the fastening of the upper cover (7) , and open it.
6 Tilt bag’s handle and remove the bag.