Zeiss VISULAS YAG III, Руководство пользователя

Страница: 51 / 126

Installation
000000-1272-175-GA-GB-060613
45
Installation of VISULAS YAG III Combi
WARNING - GENERAL HAZARDS
This device may only be installed and operated for the first time by persons
who have been authorized by Carl Zeiss Meditec.
CAUTION - GENERAL HAZARDS
Fiber optics may not be tightly bent, kinked or incompletely fastened. The
device may otherwise be damaged, causing injury to the patient or user.
CAUTION - PROPERTY DAMAGE
Never touch the end of the optical fiber with your fingers and always
protect it from contamination.
Because of the laser’s high power output, any dirt may lead to damage to
the end surface of the fiber.
Screw in the optical fiber by hand only. Do not use tools!

Observe the user manuals of VISULAS 532s and the instrument
table.
•
Avoid impact and blows during shipment of the device.
•
Remove the key from the key switch to prevent the unit from being
inadvertently switched on during installation.
•
Mount the system in a suitable location close to the physician and the slit
lamp.
To install the laser console on an instrument table, the table mounting
(1, Fig. 16) must first be fitted. Four holes are provided for this purpose
under the tabletop (on the right hand side, seen from the physician’s
perspective).
•
Screw the table mounting’s mounting plate firmly to the table top using
the screws provided.
•
Now affix the laser slit lamp to the table.
•
Slide the VISULAS YAG III from the front onto the upper plate of the table
mounting.
•
Finally, holding it vertically, slide the VISULAS 532s, from the front, onto
the lower plate of the table mounting.
•
Place the foot switch in a suitable position under the table and insert the
connector into the red socket marked VISULAS 532s (see VISULAS 532s
user manual).

In Combi mode the foot switch is always connected to the
VISULAS 532s, never to VISULAS YAG III.