Zeiss Smartzoom 5, Быстрое руководство

Страница: 4 / 34

1 Introduction | 1.1 Preparing Referencing ZEISS
1 Introduction
The Smartzoom Referencing Application is used for improving the system accuracy and find-
ing the best settings for all components that are used. We recommend to perform the full refer-
encing workflow (meaning all referencing tasks are activated) if the system was newly installed.
If you update or change components we recommend to perform the full referencing workflow
again. As you have to change objectives and tilt the stand, read the Smartzoom 5 Instruction
manual, where these procedures are described in detail.
In case of mounting or dismounting the Transmittel Light Unit (TLU) repeat the referencing
tasks Ov. Image Dist. Corr. [
}
12] and Image Alignment [
}
18] .
1.1 Preparing Referencing
To prepare the Smartzoom 5 system for referencing the following steps are required:
1. Switch on the microscope.
à
Make sure that the stage is empty and has a clean surface.
2. Switch on the computer.
à
After startup of the computer, wait for at least two minutes.
3. Start the Smartzoom Referencing application.
à
While the software starts, the hardware is initialized. When the hardware was initialized
successfully you can start the referencing tasks.
Quick Guide ZEISS Smartzoom 5 | en-US | Rev.1 4