![background image](http://html1.mh-extra.com/html/zeiss/elyra-7/elyra-7_operating-manual_3332235283.webp)
ELYRA 7
Left Tool Area and Hardware Control Tools
ZEISS
03/2019 V_02
000000-2262-999
279
5.4.4.5
System Options – Hardware
Press the
Hardware
tab to open the
Hardware
panel (Fig. 474).
Hardware
lists parameters that, when their
respective check box is ticked, will set several
hardware defaults.
By activation of the
Lasers off on exit
check box
the lasers are automatically switched off when the
ZEN software is closed. The lasers are allowed to
cool for five minutes before they are switched off.
The Z-Stack
Waitstate
function delays the image acquisition during time series or Z-Stacks in case
vibrations of the stage occur and are registered at the beginning of individual images. The default is off.
The delay is set to 350 ms. This can occur for specific image acquisition settings and is dependent on the
speed, the stage and the objective in use.
5.4.4.6
System Options – Image Display
Press the
Image display
tab to open the
Image
display
panel (Fig. 475).
If the
Apply brightness and contrast changes
to diagrams and tables
is ticked any changes in
brightness and contrast of the image will also
affect the image data shown in diagrams or tables.
If not ticked any changes in the
Image Display
will not affect the original image data. The default
setting is off.
The
Temporary files directory
can be chosen
manually by pressing the
…
button via Windows
Explorer. For large datasets it is advisable to use a
drive
other
than the C-Drive of your computer.
When ticking the
Interpolate
checkbox
Interpolates the signal between pixels and thus
smoothens the image. This interpolation is not
saved with the original image data and can be
active also during acquisition.
Ticking the
Invert x
check box will invert the x-coordinate in the display. The original data set is not
changed.
Ticking the
Invert y
check box will invert the y-coordinate in the display. The original data set is not
changed.
Ticking the
Invert z
check box will invert the z-coordinate in the display. The original data set is not
changed.
Invert time (line scan only)
- not available.
Fig. 474
System Options – Hardware panel
Fig. 475
System Options – Image display panel