Start-Up
Carl Zeiss
Unpacking, Attaching ergonomic base plate
Axiostar
plus
2-4
B 40-815 e 12/01
1
Plastic feet
2
Base pod
Fig. 2-1
Inserting base pods
2.2.1
Attaching the ergonomic base plate
•
Remove the tube if one is attached.
•
Tilt the stand back and set it down.
•
Remove the four plastic feet (Fig. 2-1/
1
)
from the stand and replace with the four
base pods included (Fig. 2-1/
2
). If necessary,
clean adhesive or varnish remains from the
drilled holes.
•
Turn over the stand and place it top side
down on a soft surface or the packing
cardboard (Fig. 2-2).
•
Secure the microscope in this position or
have a second person hold it to avoid
damaging the microscope.
•
Place the ergonomic base plate (Fig. 2-2/
1
)
on the bottom of the stand and fasten with
the four Allen screws (SW 2.5 M4 x 30
(Fig. 2-2/
2
) using the four washers.
•
Turn the microscope over and set it down
on the ergonomic base plate.
•
Reattach tube and secure.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
