Zehnder Rittling ComfoSpot 50, Инструкции по эксплуатации и монтажу

Страница: 21 / 42

EN 21
6. Install the ribbon cable in the designated fixing points, taking care to produce a smooth overlapping in the vicinity
of the 90° bends. Then snap the control panel onto the control panel carrier in the correct position.
7. In case the unit cable is not yet connected, establish the electrical connection by means of the WAGO luminaire
terminals, install and fix in place the plastic box for covering the electrical connection (see 3.2.4.1).
8. Finally, snap the interior top cover onto the bottom cover of the interior cover using the operating panel cut-out on
the curved surface.
The cut-out on the curved surface of the interior top cover must be on the side of the control panel
when being placed onto the bottom cover of the interior cover!
3.2.4.3 Connecting the external control panel
The unit-side connection of an optionally available external control panel must be established in the
course of connecting the power supply.
3.2.4.3.1 Connecting the cable for the external control panel on the ventilation unit
The cable end of the on-site cable (J-Y(ST)Y 2x2x0.6), protruding in the area of the cable entry point, for the external
control panel must be connected up as follows:
1. Pull the plug-in connector part with the screw-type terminals off the 4-pin plug connection of the pre-assembled
connecting cable (contained in scope of delivery kit, external PDA control panel).
2. Connect the four wires of the on-site cable (J-Y(ST)Y 2x2x0.6) for the external control panel to the plug-in connector
part with the screw-type terminals.