Zehnder Rittling ComfoSpot 50, Инструкции по эксплуатации и монтажу

Страница: 13 / 42

EN 13
•
Benzene or carbon tetrachloride
•
All types of "strong" cleaning agents
•
Scouring agents
•
Glass cleaners and similar
Replacing the unit filters
The ComfoSpot 50 must not be operated without filters. When changing filters, the unit needs to be
transferred to the Standby operating mode.
In ComfoSpot 50, two high-quality original filters of the class G4 are installed by default. Retrofitting a pollen filter of the
class F7 is possible. This is inserted into the lower filter compartment (outdoor air filter). The filters in the ComfoSpot 50
must be checked in accordance with the relevant notification on the control panel and, if needed, must be replaced. In
doing so, proceed as follows:
1. Put the unit into the Standby operating mode.
2. Take off the interior top cover, by disengaging the double locking connection (available on both sides) between the
bottom and top cover of the interior top cover, either on the upper or lower curve (depending on the better
accessibility). To do so, lift the relevant ends of the curved surface on the interior top cover approx. 2-3 mm upwards
or downwards (1.) and pull it out to the front and out of the guides (2.), see figure.
3. Use your finger to grasp at the side between the cellular rubber filter cap and the filter compartment opening of
the bottom cover of the interior cover and pull out the filter cap.
4. Gripping the pulling tabs, pull the filter carefully out of the filter compartment.
Depending on where accessibility is better, first undo
the upper or lower locking connections and remove the
respective internal panel in accordance with the step
sequence!
1.
1.
2.
1.
1.
2.