Zehnder Rittling ComfoD 180, Руководство для установщика

Страница: 5 / 20

EN- 5
1 Safety
Always follow the safety regulations, warnings,
comments and instructions given in this document.
Personal injury or damage to the unit can arise
from non-compliance with the safety regulations,
warnings, comments and instructions in this
document.
■
Only a certified engineer may fit, connect,
commission and maintain the unit unless
otherwise indicated in this document;
■
Installation of the unit must be carried out
in accordance with the general and locally
applicable construction, safety and installation
instructions of the local council, electricity and
water boards or other agencies;
■
The unit is only suitable for a 230V 50/60Hz
connection;
■
The unit is only suitable for residential use and
not for industrial use, such as swimming pools or
saunas;
■
Ensure while working on the unit that the
power has been controllered off and cannot be
accidentally controllered back on;
■
Always take ESD-inhibiting measures when
dealing with electronics, such as wearing an
antistatic wristband;
■
After using the user manual, place it back on the
unit;
■
It is prohibited to modify the unit or the
specifications stated in this document;
■
The unit cannot be opened without using tools;
■
It must not be possible to touch the fans by hand,
which is why ducts of at least 900 mm must be
connected to the unit.
2 Installation conditions
In order to determine whether the unit can be
installed in a certain area, the following aspects
must be taken into account:
■
The system must be fitted to allow sufficient
room around the unit for the air duct connections,
condensation drain as well as for carrying out
maintenance activities;
■
The unit must be installed in a frost-free space;
■
We do not recommend installing the unit in areas
with a higher than average humidity (such as
bathroom or wc). This will prevent condensation
on the outside of the unit;
■
The room must offer the following provisions:
- Air duct connections;
- Electrical power connection;
- Wiring for a wired control controller;
- Provisions for the condensation drain.
3 Transport and unpacking
Take the necessary precautions when
transporting and unpacking the unit and
make sure the packing material is disposed
of in an environmentally friendly manner.
Checking the delivery
Contact your supplier immediately in case of damage
or an incomplete delivery. The delivery should at
least include:
■
The unit: check the identification plate to ensure
that it is the required type;
■
2 Mounting brackets;
■
6 Spacers;
■
Service/ComfoSense connector;
■
Documentation.
Meaning of the suffixes found on the
identification plate
■
ComfoAir = Product family name.
■
ComfoD = The unit has a display installed as
default.
■
180 = Product type name
(Air volumes in m3/h)
■
Basic = The unit has a display installed as
default.
■
Luxe = The unit has no display installed as
default.
■
Enthalpie = The unit has a enthalpy exchanger
installed as default.
■
ERV = The unit has a enthalpy exchanger
installed as default.
■
PH = The unit has a pre heater installed as
default.
■
V = The unit has a pre heater installed as
default.