Zehnder Rittling ComfoAir 180, Руководство пользователя

Страница: 29 / 32

28 - EN EN- 29
6.6 Malfunctions (or problems) without alerts
Problem/Malfunction Indication Check / action
System switched off Power supply on The control circuit board is defective and must
be replaced
No power supply Mains power is off
High intake temperature
in summer Bypass remains closed Reduce the comfort temperature
ComfoAir is still in Winter mode:
Bypass remains closed The Mode of the ComfoAir can be checked in
menu P17. (0 = Wintermode)
■
Wait untill ComfoAir switches to
Summer mode (menu P17 = 1)
Low intake temperature
in winter Bypass stays open Increase the comfort temperature
Little or no air supply;
shower remains damp Filters blocked Replace the filters
Valves blocked Clean the valves
Exchanger clogged by dirt Clean the exchanger
Exchanger frozen Defrost the exchanger
Fan dirty Clean the fan
Ventilation ducts blocked Clean the ventilation ducts.
ComfoAir is in frost-protection operation Wait until the weather warms up.
Too noisy Fan bearings defective Replace the fan (bearings).
Fan settings too high Change the fan settings
Slurping noise
■
U bend is empty
■
U bend does not seal properly
Reconnect the U bend
Whistling noise
■
An air gap somewhere
Seal the air gap
Airflow noise
■
Valves do not close onto duct
■
Valves not open far enough
Reinstall the valves
Reset the valves
Condensation leak Condensation drain clogged Unblock the condensation drain.
Condensation from exhaust duct does not run
into leakage tray Check whether the connections are correct
Corded position switch
not working Cabling is not correct Check the wiring circuit of the position switch by
measuring the voltage:
■
Voltage only on N & L3:
[Fans rotate in position 1]
■
Voltage only on N & L3 & L2:
[Fans rotate in position 2]
■
Voltage only on N & L3 & L1 or
N & L3 & L2 & L1:
[Fans rotate in position 3]
Switch is defective
RFZ not working Battery is discharged Check the battery.
■
Replace the battery if necessary.
Switch will not connect to the unit Make sure the ComfoSense is turned on and
menu P893 is set to “1”
Switch is not correctly tuned Remove the power briefly from the
ComfoAir. Shortly after reconnecting
the power, tune the switch again