9
Leave throttle at close position and confirm calibrating with pressing enter , or exit calibration
with pressing - . Displayed number should be between 0 and 500.
18.
Set TPS open [100%]
(if TPS enabled)
For correct operation, TPS open position must be calibrated!
Move to
TPS open [100%]
with pressing + , or - and then press enter.
Move throttle to maximum open position and confirm calibrating with pressing enter , or exit
calibration with pressing -. Displayed number should be between 500 and 1010.
19.
TCT mode
Throttle Close spark Termination mode, reduces number of sparks (spark is active every third
revolution) above 8000rpm, when throttle is closed. TCT mode ensure better engine cooling.
Move to
TCT mode
with pressing + , or - and then press enter .
Now you can enable or disable
TCT mode
with pressing + , or - and then press enter .
20.
IGN. MAP SW
Enabling, or disabling ignition map switch, for changing ignition maps while riding.
Move to
Ign. Map SW
with pressing + , or - and then press enter .
Now you can enable or disable external switch with pressing + , or - and then press enter .
21.
PULSES PER REV
It is number of pulses per rev from pickup coil and is important for correct rev reading. Setting is
2 for all twins with wasted spark ignition system.
Move to
Pulses Per Rev
with pressing + , or - and then press enter.
Now you can change nr. of pulses per rev with pressing + , or - and then press enter .
22.
STOP SW MODE
Selects stop switch operation mode. Engine can be stopped with low level (stop switch
connected to the ground), or with high level (stop switch is opened).
Move to
Stop SW Mode
with pressing + , or - and then press enter .
Now you can select low level stop "0", or high level stop "1" with pressing + , or - and then
press enter .
