Start of Configuration
HEADER AND TRAILER
This option allows you to append a header and/or a trailer to
every message transmitted via the serial ports or the
keyboard port. There is no restriction in selecting header
or trailer characters as far as the sum of the lengths of
header and trailer is not greater than 10 digits.
Header
Trailer
Set
1. Select either header or trailer
you are going to program by
scanning the corresponding
label
2. Scan the character(s) you want
from the enclosed ASCII table to
set as header or trailer (be sure
to enable full ASCII code 39
option before you start).
3. Read the “ Set” label to set your
choice into memory.
INTER-MESSAGE DELAY
There series Laser scanners allow you to add a delay
between two consecutive messages. This delay will
be added before each data transmission. Start of
Configuration label and then select the appropriate
delay time to activate this feature.
None
100mSec
500 mSec
1 Second
8
INTER-CHARACTER DELAY
This option governs delay time between consecutive
characters. The delay time can be altered by
scanning the following labels.
None
10 mSec
20 mSec
50 mSec
MESSAGE/BLOCK MODE SELECTION
This option allows you to treat scanned data as either
an independent message or a block message. In
the message mode, the data scanned will be
transmitted immediately. In block mode, the data
scanned will be appended to the message buffer if
the scanner is programmed in block mode. A block
of message will only be transmitted after a “Send”
command is entered. This mode is only available
when the scanner is working with code 39 labels.
You are free to choose any character as the “ Send”
command.
Message
Block
End of Configuration
9
