Connecting to a Power Source
11
Installing the Wireless AP
Installing Antennas
You may install optional 2.4 or 5GHz antennas on top of the wireless AP to
extend the range of your wireless network.
Caution - Make sure that you disconnect the wireless AP from the power
source before connecting the optional antennas.
Caution - Do not remove the metal caps if you are not installing 2.4 or 5GHz
antennas.
1.
Unscrew the metal caps protecting the antenna connectors.
2.
Connect the antennas to the standard N-type female antenna connectors on
the AP.
Figure 3-3. Installing Antennas
Connecting to a Power Source
The wireless AP comes with a PoE injector kit for connecting to power over
the Ethernet port. The wireless AP automatically turns on as soon as it is con-
nected to a power source.
Caution - Use only the PoE injector that came with the wireless AP.
Caution - Make sure that the PoE injector is properly grounded.
1.
Insert one end of an Ethernet cable to the P+D/OUT on the PoE injector.
2.
Insert the other end to the Ethernet port on the wireless AP.
3.
Insert one end of an Ethernet cable to the Data/IN port on the PoE injector.
4.
Insert the other end to the assigned LAN port on the wireless AP controller.
2.4GHz Antenna
Connector
5GHz Antenna
Connector
5GHz Antenna
Connector
2.4GHz Antenna
Connector
