31 / 103
Identification: MD-AL-GI-00
Rev. 1.1 of 12/03/2021 - Application: GID
User’s Manual 1PH 1100TL-3300TL-V3
Rev. 1.1 12/03/2021
Figure 20 - Connecting the DC input power cables (2)
5)
Insert the crimped power cables in the corresponding seats until you hear a “click” sound. At that
point, the power cables will snap into place.
6)
Replace the cable glands on the positive and negative connectors and rotate them against the
insulation covers.
7)
Insert the positive and negative connectors in the corresponding DC input terminals of the inverter
until you hear a “click” sound, as shown in the figure.
Figure 21 - Connecting the DC input power cables (3)
Removal
procedure
To remove the positive and negative connectors from the inverter, insert a removal tool in the bayonet
coupling and press the tool with adequate force, as shown in the figure below.
Before removing the positive and negative connectors, make sure that the
inverter’s circuit breaker is switched off. If not, the direct current may cause an
electric arc that could result in a fire
Warning
