Zaxcom ZFR100, Руководство пользователя

Страница: 14 / 28

Chapter 2 ZFR100 Recording System Owner’s Manual
10
ZFR100 Recording Operation
Card Formatting
The memory card must be formatted by the ZFR100 before recording is possible.
To format the memory card do the following.
1. With the power off insert the memory card into the ZFR100
2. When the unit has fully initialized, press the menu key repeatedly until the instruction appears
in the display indicating how to erase the memory card.
3. Press the up arrow key 5 times to begin the Erasing and formatting of the memory card.
The ZFR100 displays its progress in formatting the memory card.
Important:
Ensure the ZFR100 indicates that the formatting was successful before the card is used for actual
recording. If the formatting fails
do not
use the memory card for recording in the ZFR100.
A 2 GB MiniSD card takes approximately 20 seconds to format.
Jamming ZFR100 Time Code
Time code is jammed into the ZFR100 by connecting it to the microphone input. When time code is
connected it takes the ZFR100 about 3 seconds to recognize the time code input. The display shows
TIME CODE when the code is recognized and the word Jammed a second later. When Jammed
disappears the time code input can be disconnected.
The audio level of the time code needs to be between 0 dB and +10 dB on the ZFR100 meter. A line
level to mic level cable should be used to attenuate the time code signal out of a generator to the
correct audio level.
The ZFR100 automatically identifies the time code rate and type. It sets itself to that rate when the
ZFR100 is jammed. Time code accuracy of the ZFR100 is about 1 frame in 5 hours.
Time code may also be jammed using the optional STA100 stereo adaptor, TCA100 time code
adaptor, or by sending time code to the TCR100 internal time code receiver from the IFB800 time
code/remote control transmitter.
Jamming time code on the ZFR100 will start a new file in the ZFR100. The file shows up in the
Zaxcom conversion utility starting at the time code location the ZFR100 was jammed at.
Important:
The ZFR100 will not keep time code running with power off.