Zauber ECO-5800 © ZAU Grupp 2013 (ENG)
Page 28 of 32
Cleaning
WARNING!
Before cleaning always disconnect from mains power
supply. Under no circumstances should you immerse the
device in water for cleaning purposes. Otherwise this
might result in an electrick shock or fire.The mixer blades
are sharp! Risk of injury.
CAUTION!
Do not use a wire brush or any obrasive items.
Do not use any acidic or abrasive detergents.
The mixing jug is not dishwasher safe.
Do not rinse the mixing jug in a bowl of water either.
The base of the mixing jug contains electronic components
that must no get wet.
Should water however penetrate the base of mixing jug.
Allow to dry completely before you use it again.
For cleaning the outside of the machine use only a damp
washing-up cloth.
Mixing Jug
Fill the mixing jug with about 1 liter water by adding a few
drops of dishwashing liquid.
Heat up the water for about 8 minutes at cooking setting
«Het».Press the «Blender» button briefly.
Allow the water to cool before cleaning the inside wall
of the mixing jug.Clean the mixing jug from the inside
with the cleaning brush provided. Rinse off the mixing jug
witch clean water and carefully dry it off.
Lid and cap
Clean these components in a rising bath. Rinse wuth clean
water. Dry the parts off.
Storage
Malfunction
Possible cause
Remedy
The device does
not function.
The device is not supplied
with power.
Check the outlet with a
different device.
Insert the power plug
correctly.
Check yor domestic fuse.
The safety switch is not
closed.
The device is deffective.
Check that the mixing
jug and the lid are fitted
correctly.
Contact our Servise or
a specialist.
Liquids are not
mixed correctly.
You have too much or too
little liquid in the vessel.
Start with a lower speed
which you can increase
later.
The speed is too high.
Vary the quantity of the
liquid.
The blades become
blocked after tur-
ning on.
The selected speed is too
low.
Start at a higher speed.