Zass ZPAC 09, Руководство по эксплуатации

Страница: 4 / 28

2. KEY TO MACHINE PARTS (Page 2)
- Outlet blade;
- Inflow;
- Heat storage; - Preset;
- Control panel;
- Cool preset;
- Hour; - Mode;
- Cover;
- Dehumidify;
- Heat; - Speed;
- Handle;
- Strong cold;
- Ventilation; - Swing;
- Side plate;
- Cool;
- Degree;
- Front plate;
- Digital display;
- Timing;
- Roller;
- Cool storage; - Power supply;
- Heat preset;
- Back air inlet grille;
- Lack water; - Drainage;
- Drainage;
- Water inlet and knob;
- Low temp; - Inflow;
- Swing;
- Water outlet and knob;
- Wi-Fi; - Timing;
- Energy;
- Back plate;
- High temp; - Button “-”;
- Wind speed;
- Power cord;
- Full; - Button “+”;
4
1
1
13 30
A
B
B B
A
B B
B
A
B
B B
A
B B
B
A
B
B B
A
B B
B
A
B
B B
A
B B
B
A
B
B
A
B B
B
A
B
B
A
B B
2
2
14 31
3
3
15 32
4
4
16 33
5
5
17
6
6
18
7
7 24
19
8
8 25
20
9
9 26
21
10
10 27
22
11
11 28
23
12
12 29
• When cold / heat storage, please open doors and windows for ventilation.
• After the function switch, the compressor enters the protection state. You must wait
for 3 minutes before the compressor can operate normally.
• When the compressor starts, there is a little noise of two-phase flow. After the
compressor starts. The noise of two-phase flow will disappear.
• After the completion of drainage, screw off the inlet / outlet pipe and take it off the machine. Otherwise,
siphonage will occur. Even if the drainage has stopped, water will flow out of the machine.
• Even if the drainage function of the machine is used to drain the water in the tank, the water cannot be
completely drained. Therefore, when moving, carrying and storing, the machine body should be upright
and not dumped. In case of toppling, do not start the power supply immediately, it should be placed for
a period of time, and start the power supply after the water is completely evaporated.