AUTOMATIC GATE OPENER
• G452 Installation Manual
20
Step 17
Connect the color-coded gate opener (actuator) wires
to the terminal block located on the bottom of the con-
trol board marked Opener 2 (DUAL). Do this by insert-
ing the wires into the terminal block and tightening the
set screw in the terminal block (
fig. 28
).
1. Connect the RED gate opener (actuator) wire to the
OPENER 2 (DUAL) RED terminal.
2. Connect the BLACK gate opener (actuator) wire to
the OPENER 2 (DUAL) BLK terminal.
3. Connect the BROWN gate opener (actuator) wire to
the OPENER 2 (DUAL) BWN terminal.
4. Connect the BLUE gate opener (actuator) wire to the
OPENER 2 (DUAL) BLU terminal.
Step 18
After connecting both gate opener (actuator) wires to
their proper locations, tighten the strain relief screw so
the gate opener (actuator) cables do not move or slide
through the strain relief (
fig. 29
).
Screw
Figure 29
Gate opener
cable
Figure 28
Strain relief housings
Gate opener cables
Figure 27
Step 15
(fig. 26)
Connect the color-coded gate opener (actuator) wires
to the terminal block located on the bottom of the con-
trol board marked Opener 1 (SINGLE). Do this by insert-
ing the wires into the terminal block and tightening the
set screw in the terminal block.
1. Connect the RED gate opener (actuator) wire to the
OPENER 1 (SINGLE) RED terminal.
2. Connect the BLACK gate opener (actuator) wire to
the OPENER 1 (SINGLE) BLK terminal.
3. Connect the BROWN gate opener (actuator) wire to
the OPENER 1 (SINGLE) BWN terminal.
4. Connect the BLUE gate opener (actuator) wire to the
OPENER 1 (SINGLE) BLU terminal.
Step 16
Insert the second gate opener (actuator) cable through
the second strain relief housing and into the control
box. Feed the gate opener (actuator) cable into the con-
trol box (
fig. 27
).
NOTE:
Protect the second gate opener cable (40’ foot
cable) in a PVC conduit pipe that is buried under
ground. This protects the cable from damage by vehi-
cles, lawnmowers, or weedeaters.
Gate opener
cable
Figure 26
Terminal Block
Correct
Wrong
Wrong
