Zareba B10LI, Руководство пользователя

Страница: 37 / 44

- 37 -
Test fence line voltage regularly at the furthest point on the fence from the
fence controller to ensure voltage is adequate for the animal being controlled.
Inadequate voltage
Adequate voltage
reading –
fence line OK
Ensure power supply is sufficient
(battery/AC power)
Replace/repair battery
or AC power to
fence controller
If power OK, disconnect FENCE and GROUND wires
from fence controller, then check voltage output by
touching metal part of terminals with tester.
If output is normal (over 5,000 volts*),
reconnect FENCE/GROUND wires
If output is less than 5,000 volts* there is a
fence controller fault. Call Zareba for assistance.
Test ground system – it should read less than 400 volts on ground rod. If over 400 volts,
add extra ground rods or make them deeper. Test again/add more ground rods until
ground system reads under 400 volts. Remember grounding is affected by soil conditions.
If grounding is OK, test the hook-up wire that connects the fence controller to
the fence line. Disconnect hook-up wire from fence line and test.
Under 4,500 volts*
Hook-up wire is leaking to ground.
Ensure you are using 20 KV insulated
hook-up wire. Replace and recheck.
Over 4,500 volts*
Turn off fence controller and reconnect
the hook-up wire to fence line.
Poor hook-up
wire
connections
Poor
jumpers
between
lines
Poor fence
line splices/
conductors
Fence line
short or leak
to ground
Leaking
hook-up wire
under
gateway
Very heavy
vegetation
against the
fence line
Metal object
touching
fence line
Bad or
incorrect
insulator
Fence line
touching a
fence post
Faulty
connections
at gate
openings
If you cannot resolve the problem please call Zareba Systems at 800-800-1819.
* (2,000 volts for models 10ACRE, 20 ACRE, ACC2, 33C, RS3 or SP3)
* (1,500 volts for models 10ACRE, 20 ACRE, ACC2, 33C, RS3 or SP3)
Check fence line
3
5
1
4
2
Testing/Troubleshooting