Zanussi ZWY 61024WI, Руководство пользователя

Страница: 13 / 20

MAINTENANCE WASH
With the low temperature programmes it is possible
that some detergent stays in the drum. Perform a
maintenance wash regularly. To do this:
• Remove all laundry from the drum.
• Select the cotton programme with the highest
temperature with a small quantity of detergent.
LID SEAL
Regularly examine the seal. Clean it when needed,
using ammonia cream cleanser agent without
scratching the seal surface,
Always obey the instructions that you
find on the packaging of the product.
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0°C, remove the
remaining water from the inlet hose and the drain
pump.
Do this procedure also when you want
to do the emergency drain.
1. Close the water tap.
2. Remove the water inlet hose.
3. Remove the drain hose from the rear support
and unhook it from sink or spigot.
4. Put the ends of each drain and inlet hose in a
container. Let the water flow out of the hoses.
5. Set the Drain programme and let it operate until
the end of the cycle.
6. Turn the programme knob to position Marche/
Arrêt to deactivate the appliance.
7. Disconnect the appliance from the mains
socket.
WARNING! Make sure that the
temperature is more than 0°C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
CLEANING THE INLET HOSE AND THE VALVE FILTER
1
2
3
1 2 3
90˚
4
CLEANING THE DETERGENT DISPENSER
1
2
1 2 3 4
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
INTRODUCTION
The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer to
the table). If not, contact the Authorised Service
Centre.
With some problems, the acoustic signals operate.
The indicator of button
flashes in red and one
of the indicators comes on, to show an alarm code:
13