Zanussi ZOG10311, Руководство пользователя

Страница: 19 / 24

A B
2. Release the screw (C), which keeps the
burner in position.
C
3. Carefully move the burner off the injector
support (D).
D
F
E
4. Slowly move it to the left side. Do not apply
force to the wire of the spark plug
connector (F) and to the thermocouple
conductor (E).
5. Release the burner injector (D) with a 7 mm
socket spanner and replace it with a
different one which is necessary for the type
of gas you use.
Refer to “Technical information” chapter.
6. Assemble the burner in a reverse sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new gas
type.
The gas oven burner does not need any primary
gas regulation.
Make sure that the gas supply
pressure of the appliance obeys the
recommended values.
If the supply gas pressure is
changeable or different from the
necessary pressure, you must fit an
applicable pressure adjuster on the
gas supply pipe.
Minimum level adjustment of the oven
burner
1. Disconnect the appliance from the
electricity.
2. Turn the knob for the gas control to the
minimum position and remove it.
3. Adjust the adjustment screw (A) with a thin-
bladed screwdriver.
A
Change of
the type of
gas
Adjustment
of the adjust-
ment screw
From natural gas
to liquid gas
Fully tighten the
adjustment
screw in.
From liquid gas
to natural gas
Release the ad-
justment screw
approximately
1/3 of a turn.
4. Attach the knob for the gas control.
5. Connect the appliance to the electricity.
WARNING!
Only put the mains plug into the
mains socket when all parts are
back into their initial position. There
is a risk of injury.
6. Light the gas oven burner.
Refer to "Daily use" chapter.
7. Set the knob for the gas control to the
maximum position and let the oven heat for
at least 10 minutes.
8. Turn the knob for the gas control from the
maximum to the minimum position.
www.zanussi.com 19