Zanussi ZGS 782 ICT, Инструкция пользователя

Страница: 8 / 32

8
Lighting the burners Lighting the burners
Lighting the burners Lighting the burners Lighting the burners
For easier lighting, proceed before putting For easier lighting, proceed before putting For easier lighting, proceed before putting For easier lighting, proceed before putting For easier lighting, proceed before putting
a pan on the pan support.
a pan on the pan support.
a pan on the pan support. a pan on the pan support.
a pan on the pan support.
To light a burner:
z
turn the relevant knob anti-clockwise to maximum
position ( ), then push it down to ignite the
burner.
z
Upon ignition, keep the knob pushed down
about 5 seconds
5 seconds 5 seconds 5 seconds 5 seconds. This will allow the
"thermocouple" (see diagram - letter D ) to be
heated and the safety device to be switched
off, otherwise the gas supply would be
interrupted.
z
Then adjust the flame as required.
If the burner does not ignite, turn the control knob
to zero, and try again.
If you cannot light the flame even after
severalattempts, check the "cap" (see diagram
- letter A
A
A A A) and the"crown" (see diagram - letter
B B
B B B) are in the correct position.
)
Operation Operation
Operation Operation Operation
Hob burners control knobs Hob burners control knobs
Hob burners control knobs Hob burners control knobs
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
A A
A A A - Burner cap
B
B B B B - Burner crown
C
C
C C
C - Ignition electrode
D
D D D D - Thermocouple
A
B
C
Triple crown burner
D